5. Secure the tank to the machine using the adjustable strap. Remove
slack by pulling on the loose end and securing back to strap.
Pressure Liquid Level Sight Valve
Relief
Valve
Bleeder Valve Service Valve
TO REMOVE THE PROPANE TANK, unstrap the tank, disconnect the hose coupling and remove the tank from the shroud housing.
!
Starting the Machine
Catalytic mufflers require a few minutes to warm up before effectively removing harmful emissions. Make sure there is proper ventilation during the warm-up period.
1. Check oil and fuel levels.
2. Check and clean engine dust filter. NEVER run continuously for
more than 1 hour without cleaning or changing engine dust filter.
3. Check carburetor air filter. Change if necessary.
4. Open the propane service valve SLOWLY to allow pressure to
equalize in hoses. Opening quickly may cause the flow check valve
to engage, limiting fuel flow.
For the STEALTH:
1. Allow machine to tilt backward (pad off floor).
2. With the bail throttle in the IDLE position, engage the starter by turning
the ignition key switch to the starting position for approximately 5
seconds.
3. If the engine does not start, release the key switch for 10 seconds,
then try to start again by turning the key switch for 5 seconds.
4. After the engine has started, allow the engine to warm up for
approximately 30 seconds.
OPERATOR’S MANUAL
22
