!
DO NOT tamper with the original emission related parts.
Tampering with the Emission Control System is prohibited and will
VOID THE WARRANTY.
WARNING
WARNING indicates injury may occur to you or other persons if safety precautions are ignored or are not adhered to. Read and observe all WARNING statements found in the Operator’s manual and on the machine.
‣
Modifications or alterations to the machine can lead to personal
injury or damage to the machine. DO NOT make unauthorized
modifications or alterations to the machine; this VOIDS ALL
WARRANTIES.
‣
The muffler and engine become hot while in operation and remain
hot long after the machine is shut off; this can cause severe burns.
DO NOT touch these parts of the machine until they have
cooled.
‣
To avoid injury safety goggles, safety shoes and safety clothing are recommended while operating the machine.
‣
Continuous exposure to high noise levels can cause hearing loss.
Hearing protection is recommended while the machine is in operation.
‣
Machine vibration may cause tingling or numbness in the fingers or hands. Gloves are recommended to reduce machine vibration. If tingling or numbness persists, shut off the machine. If the vibration is caused by loose parts, adjust or tighten these parts before using the machine again.
CAUTION
CAUTION indicates damage may occur to the machine or to other property if safety precautions are ignored or are not adhered to. Read and observe all CAUTION statements found in the Operator’s manual and on the machine.
‣
NEVER overfill the propane tank. ONLY fill to 80%. Overfilling the propane tank is the number one cause of problems with a propane machine. Overfilling may cause the engine to run poorly or not at all.
‣
A dirty engine filter can cause overheating. Check and replace following recommended maintenance schedule page .
‣
Overheating can be caused by dirty or insufficient or low levels of oil.
Check oil before each use, and fill or change as needed.
OPERATOR’S MANUAL
7
