5 .17 Modules Present. Actron CP9690 Elite AutoScanner

The CP9690 Elite AutoScanner is designed to help diagnose vehicles and assist in troubleshooting procedures. It monitors vehicle events and retrieves codes from the vehicle's control modules to help pinpoint problem areas. This scan tool also supports OBD I DLCs used by Ford, GM, Chrysler, and Toyota.

PDF

Document

en | 4 4 | User guide | CP9690 Elite AutoScanner®

Test Results

DLC KOEO Voltage

DLC Cranking Voltage

DLC KOER Voltage

12.2

10.4

14.7

Special Tests

O2 Monitor Tests

Diagnostic Monitor Tests

On-Board Systems

Vehicle Information

Oil Light Reset

Charging System Monitor

Modules Present

Component Locator

Acronyms ess ENTER to view the data plot.

On the first screen, the scan tool didn’t detect that the engine had started, so there isn’t a KOER voltage reading.

The second screen did detect that the engine had started so there is a KOER reading.

The screen on the left shows that the KOEO voltage before an engine start was attempted was 12.2V. Once the starter began cranking the engine, a cranking voltage of 10.4V was measured. After the engine started, a KOER voltage reading of 14.7V was measured.

• If the KOEO voltage is very low, this could be an indication of a bad battery, or one that needs to be charged.

• If the cranking voltage is a lot lower than the KOEO voltage, than this is an indication of a worn starter.

• If the KOER voltage is not higher than the KOEO voltage, than this indicates a bad or weak alternator.

After reviewing the test results, Press to view the data plot.

7. View the data plot.

• The triangle below the graph indicates the position of the frame in the graph.

• Use the LEFT and RIGHT arrow keys to scroll back and forth through graph.

DLC Pin 16 Voltage

14.7

10.6

The types of protocols (communication types) supported by the scan tool are:

• ISO 9141-2 protocol is shown as ISO.

Modules Present

ID Protocol

$40 ISO*

Press ENTER to continue

• SAE J1850 protocol is shown as VPWM or PWM.

Modules Present

ID Protocol

$10 VPWM*

Press ENTER to continue

Modules Present

ID Protocol

$10 PWM*

10.4

Frame: 0 Time: 0.00

Press ENTER to continue

8. Press to return to the Special Tests Menu.

5.17 Modules Present

The scan tool identifies the module IDs and communication type for all Global OBD II modules in the vehicle.

From the Special Tests Menu:

1. Select Modules Present.

• Use the UP and DOWN keys until Modules

Present is highlighted.

• Press .

• ISO 15765-4 protocol is shown as CAN.

Modules Present

ID Protocol

$01 CAN*7e9

$00 CAN*7e8

Press ENTER to continue

573464 | REV. A | 07.2015

Bosch Automotive Service Solutions Inc.

Key features

OBD II compliant
Supports OBD I systems
CodeConnect feature
Drive cycle monitor
O2 monitor tests
Diagnostic monitor tests
On-board systems
Vehicle information
Oil light reset
Battery reset

Frequently asked questions

From the System Setup menu, select English/Metric and then select the desired measurement unit. You can also change the measurement units in View and Record Data.

From the System Setup menu, select Auto-Power Off and then select the desired time.

The CodeConnect feature allows you to access vehicle-specific repair information. To use CodeConnect, simply select the CodeConnect button on the scan tool's main menu.

User questions

Jennifer B.

How to clear a Permanent Diagnostic Trouble Code (DTC)?

Permanent DTCs cannot be erased using a scan tool's erase function. These codes are automatically cleared by the vehicle's on-board computer once the system determines that the fault is no longer present.