CP9690 Elite AutoScanner® | User guide | 37 | en
This Drive Cycle
Catalyst Mon
Oxygen Sens Mon
Oxygen Sens Htr
EGR/VVT Sys Mon
OR
Since DTCs Cleared
Misfire Monitor
Fuel System Mon
Comp Component
Catalyst Mon
Htd Catalyst
Evap System Mon
Sec Air System
A/C Refrig Mon
Oxygen Sens Mon n/a inc n/a n/a ok ok ok ok ok
OR
Since DTCs Cleared
4. Return to Special Tests Menu.
• Press .
inc
inc
inc inc
• The scan tool display is continuously updated.
Monitors that are “ok” will disappear and only the “inc” monitors will remain displayed. Monitors designated “n/a” are not displayed.
• When all Monitors are “OK”, a screen stating “All supported monitors are OK” will display.
This Drive Cycle
All supported monitors are OK
Press ENTER to continue
All supported monitors are OK
Press ENTER to continue
5.10 O2 Monitor Tests
OBD II regulations require applicable vehicles monitor and test oxygen (O2) sensors to determine problems related to fuel and emissions. The O2 Monitor Tests allows retrieval of completed O2 sensors monitor test results.
• The O2 Monitor Tests is not an on-demand test. O2 sensors are not tested when selected via the menu.
O2 sensors are tested when engine operating conditions are within specified limits.
• If the vehicle communicates using a controller area network (CAN), O2 Monitor Tests are not supported by vehicle. A message is displayed. Refer to “5.11
Diagnostic Monitor Tests” on page 38 for O2 monitor data.
• O2 sensors are located before (upstream) and after
(downstream) catalyst(s). Sensors are named (xy) for their position to both cylinder banks and catalysts.
– The O2 sensor for cylinder bank 1 has prefix 1y while O2 sensor for cylinder bank 2 has prefix
2y.
– The O2 sensor upstream of catalyst (closest to engine) has suffix x1 while O2 sensor downstream of catalyst has suffix x2. If vehicle contains more catalysts, O2 sensor downstream of second catalyst has suffix x3 and O2 sensor downstream of next catalyst has suffix x4.
– For example, O2S21 is upstream O2 sensor for cylinder bank 2.
The following O2 Sensor Tests are available:
• Rich-to-lean sensor threshold voltage
• Lean-to-rich sensor threshold voltage
• Low sensor voltage for switch time
• High sensor voltage for switch time
• Rich-to-lean sensor switch time
• Lean-to-rich sensor switch time
• Minimum sensor voltage test cycle
• Maximum sensor voltage test cycle
• Time between sensor transitions
• Sensor period
• Manufacturer specific tests
From Special Tests Menu:
1. Select O2 Monitor Tests.
• Use the UP and DOWN keys until O2
Monitor Tests is highlighted.
• Press .
Special Tests
I/M Monitors
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Charging System Monitor
Bosch Automotive Service Solutions Inc.
573464 | REV. A | 07.2015
