Surface Controls. Frigidaire Gas cooktop

Before Setting Surface Controls

Assembly of the Surface Burner Heads, Burner Caps and Burner Grates (Porcelain & Stainless

Steel Cooktop models)

It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations.

1.

Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads.

2.

Discard all packing material located under Burner Heads (if applicable).

3.

To replace the Burner Heads & Caps, match the letters located under center of Burner

Caps with the letters located inside Burner Heads (Figure 1).

4.

Match Burner Skirts (some models) or the emboss on the cooktop with Burner Heads and

Burner Caps (see Figure 1). Replace the Burner Heads and Caps on cooktop (see Figure

2). Carefully align the Electrodes into slot or hole of each Burner Head (Figure 3). Note:

The Burner Heads should sit flat on Cooktop Burner Skirts.

5.

Unpack Burner Grates and position on the cooktop.

REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING

AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS

ORIFICE HOLDER OPENING. Always keep the Burner Caps and

Burner Heads in place whenever the surface burners are in use.

Electrodes must align into slot or hole for each

Burner Head.

Figure 2

Figure 1

(some models)

Assembly of the Surface Burner Heads, Burner Caps and Burner Grates (Ceramic Glass

Cooktop models)

It is very important to make sure that all of the Surface Burner

Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations.

1. Be sure to follow the Installation Instructions before installing and using your new cooktop.

2. Remove all packing tape from cooktop. Remove Burner Caps and Burner Heads (See Figure 3).

3. Discard all packing material located under all Burner Heads (if applicable).

4. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside

Burner Head (See Figure 5). Place all Burner Heads & Caps on the cooktop while carefully aligning the Electrodes into slots or holes of the Burner Heads (Figure 4). Note: The

Burner Heads should sit flat on Cooktop Burner Skirts.

5. Unpack Burner Grates. NOTE: Do not force End Burner

Figure 4

Figure 5

Electrodes must align into slot or hole for each

Burner Head.

Grate Pin

Burner

Cap

Pilot hole

Figure 3

Grates down on cooktop. Be careful to line up the 2 Grate

Pins located on each of the 2 End Burner Grates into the

Pilot holes located on top of the Burner Caps (See Figure 5). Position Burner Grates on cooktop and check that all the

Burner Grate legs lie on the glass surface.

REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE

GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use.

6