DS-K5604A Series Face Recognition Terminal User Manual
Chapter 6 Quick Operation
6.1 Select Language
You can select a language for the device system.
After the device activation, you can select a language for the device system.
By default, the system language is English.
6.2 Set Application Mode
After activating the device, you should select an application mode for better device application.
Steps
1. On the Welcome page, select Indoor or Others from the drop-down list.
16
DS-K5604A Series Face Recognition Terminal User Manual
2. Tap OK to save.
Figure 6-1 Welcome Page
17
DS-K5604A Series Face Recognition Terminal User Manual
●
●
●
●
Note
You can also change the settings in System Settings.
If you install the device indoors near the window or the face recognition function is not working well, select Others.
If you do not configure the application mode and tap Next, the system will select Indoor by default.
If you activate the device via other tools remotely, the system will select Indoor as the application mode by default.
6.3 Set Network Parameters
After activation and select application mode, you can set the network for the device
Steps
1. When you enter the Select Network page, tap Wired Network or Wi-Fi for your actual needs.
18
DS-K5604A Series Face Recognition Terminal User Manual
Figure 6-2 Select Network
Note
Disconnect the wired network before connecting a Wi-Fi.
2. Tap Next.
Wired Network
Note
Make sure the device has connected to a network.
If enable DHCP, the system will assign the IP address and other parameters automatically.
If disable DHCP, you should set the IP address, the subnet mask, and the gateway.
19
DS-K5604A Series Face Recognition Terminal User Manual
Wi-Fi
Select a Wi-Fi and enter the Wi-Fi's password to get connected.
Or tap Add Wi-Fi and enter the Wi-Fi's name and the password to get connected.
3. Optional: Tap Skip to skip network settings.
6.4 Set Administrator
After device activation, you can add an administrator to manage the device parameters.
Before You Start
Activate the device and select an application mode.
Steps
1. Optional: Tap Skip to skip adding administrator if required.
2. Enter the administrator's name (optional) and tap Next.
20
DS-K5604A Series Face Recognition Terminal User Manual
Figure 6-3 Add Administrator Page
3. Select a credential to add.
Note
Up to one credential should be added.
21
DS-K5604A Series Face Recognition Terminal User Manual
: Face forward at the camera. Make sure the face is in the face recognition area. Click to capture and click to confirm.
: Enter the card No. or present card on the card presenting area. Click OK.
4. Click OK.
You will enter the authentication page.
Status Icon Description
/
Device is armed/not armed.
/
Hik-Connect is enabled/disabled.
/ /
The device wired network is connected/not connected/connecting failed.
/ /
The device' Wi-Fi is enabled and connected/not connected/enabled but not connected.
Shortcut Keys Description
Note
You can configure those shortcut keys displayed on the screen. For details, see Basic Settings .
●
●
Enter the device room No. and tap OK to call.
Tap to call the center.
Note
The device should be added to the center, or the calling operation will be failed.
Enter password to authenticate.
22
