86-B1411-1101.0
= LED BEACON
Permanent Mount
WIRING | FP# FLASH PATTERNS
RED: To +VDC for Cruise Mode
. 1 Double [R65]
BLACK: To Chassis Ground (-) > | Singe Hz]
RED + While: To +VDC for Warning Mode 3 | Quad 12H]
: Flash patterns & Synchronization à | Single [SAE]
Connect wires of all unit together for synchronization. Doubl [SAE]
(All unit should be set to the same Flash Pattern) > _
6 Quad [SAE]
OPERATION 7 | Quint [SAE]
For Flash Pattern Selection: 8 | Mega
While activating a warning mode, momentarily apply 9 | Ultra [SAE]
wire to +VDC:
+ Once to next pattern
* Quick three times to FP#1
(refer to Flash Pattern Chart)
10 | Single-Quad
11 | Single H/L
12 | Single Column Rotator
13 | Double Column Rotator
For Simultaneous or Alternating Synchronization: 14 | Double Rotator xs > Quint хо
1. Enter SETTING MODE by powering up with and RED _ Note: Actual approval will be based on model ordered.
wires simultaneously, then remove wire from +VDC.
The beacon will display short flashes:
e Single flash = Group 1
¢ Double flash = Group 2
2. Momentarily apply wire to +VDC to change Groups:
e Lightheads of the same Group will flash together.
* Lightheads of the different Group will flash alternately.
3. Save and exit SETTING MODE by disconnecting all power.
Г à
1. Open beacon
Push down on Tab O. and twist the dome Mounting П [
counterclockwise Q , then lift the dome to open. Screw |
2. Change pattern
While activating Warning Mode, momentarily push the
RED BUTTON @ to change to the next flash pattern.
(See Flash Pattern Chart)
3. Close beacon
Align dome indent © before Tab 1)
then twist clockwise (=) to close.
Beacon
Base
Mounting
Pad
Mounting
Surface
|
Mounting |
Washer м ——— Mounting
Nut
TUT Lo
O 1; 1. Drill holes on the mounting surface for wire exit and
mounting screws.
2. Secure the beacon onto the mounting surface with
supplied screws.
L y
">
